Services
Wolf appliances we repair
One manufacturer, a short list of appliance families, and a flat $80 diagnostic that comes off the bill if you go ahead with the repair.
What comes through most often
-
Range and rangetop
Burners that will not light, a griddle that runs cold at one end, an oven that reads one temperature and holds another. Sealed burners, igniters, spark modules, valves and the electric oven side of a dual fuel range.
-
Convection steam oven
A steam oven is a water system with an oven built around it, and its faults run in a fixed order — passages first, sensing second, the generator last. Caught early it is a clean; caught late it is a part.
-
Built-in wall oven
Single and double built-in ovens, plus the warming drawer and speed oven that usually share the same cabinet run. Sensors, elements, hinges, seals and the convection fan that moves the heat.
-
Cooktop and induction
Sealed gas burners that spark without lighting, induction zones that cut out under a pan, electric elements that never reach temperature. The cooktop is the appliance a coastal kitchen is hardest on.
-
Hoods and ventilation
Wall hoods, island hoods, downdrafts and the in-line or remote blowers that serve them. Salt air kills blower bearings on the coast, and a tight house starves the hood no matter how big the motor is.
-
Built-in coffee system
The most heavily cycled appliance in the kitchen, and the one with the tightest tolerances. Grinders, brew units, pumps, heaters and milk circuits, diagnosed in the cabinet the unit was built into.
What each of them costs to put right
Money
What does a repair on this bench cost?
One fee to find out which band you are in, then the band itself.
| Work | Parts and labour |
|---|---|
| Diagnostic visit | $80 flat, credited |
| Igniter or spark module replacement | $190–$500 |
| Convection fan or motor | $250–$730 |
| Oven thermostat or temperature sensor | $170–$520 |
| Burner valve or orifice service | $210–$650 |
Bands, not quotes: they are what this work has actually cost, parts and labour together, from $80 at the door to the firm figure that goes on paper after the diagnosis. The whole table
- What does a Wolf repair cost in St. Johns County?
- A flat $80 to diagnose, credited to the repair, then the band the failed part sits in: Igniter or spark module replacement runs $190–$500, convection fan or motor $250–$730, parts and labour together. Nothing is ordered before you have that in writing.
- What is covered after the work is done?
- 90 days on labour, 365 days on parts, genuine OEM parts only. Dated from the invoice, and a return visit for the same fault inside the labour window is not billed again. EPA Section 608 certified technicians handle anything involving refrigerant.
- When is replacing cheaper than repairing?
- Replacing instead of repairing runs $5,200–$10,500 (wall oven or built-in oven, the usual repair-or-replace comparison) or $8,500–$16,500 (dual-fuel or gas range, 36 inch and up). A comparable Wolf range, rangetop or wall oven, appliance only — before delivery, installation, ventilation or cabinetry. National appliance pricing, not Florida labour.
What people said after work on these
Customer feedback
Across the bench
4.3 out of 5, across 87 customer reviews. Each entry below is one visit, in the words of the person who paid for it.
The fan in the steam oven had begun to whine loudly. He changed the motor and cleaned out the housing. It is quiet again, but the first part that came was wrong and that added a week to it.
Casper X.
Water pooled under the tank housing after every run. He found the overflow pipe pushed off its stub behind the panel, refitted it with a clip, and dried out everything underneath before he left us.
Emeline T.
Two sealed burners lit slowly and smelled of gas before they caught. He stripped the caps, cleared every port and swapped a spark electrode that had gone soft. Works properly; the invoice took its time reaching me.
Evander T.